![]() ![]() ![]() ![]() These two installation methods are covered at the end of this article. However, as this is a special upgrade, there are two different methods of how you must perform the upgrade depending on the type of your appliance. This upgrade can be installed both on CloudGen Firewalls and on Control Centers. Important Note for Users Wanting to Upgrade from Firmware Release 8.2.2Īs of February 6, 2023, you can now upgrade from firmware release 8.2.2 to firmware release 8.3.1. After that, you can update to 8.x without repartitioning. If you operate a firewall with firmware version 7.2.5 or earlier, you must repartition the hard disk with the layout listed below and fresh install firmware 8.0.6.In this case, you can upgrade directly to firmware 8.x without repartitioning the hard disk. If you operate a firewall that was shipped from the factory with firmware 7.2.6, or if you have already repartitioned the hard disk and performed a fresh install of firmware 7.2.6, then the hard disk already has a partition layout that is suitable for firmware 8.x.Ensure that the partition layout of your firewall/Control Center applies to the values in the table of the paragraph "Disk Space Requirements" below. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |